English Japanese
To stop authselect from managing your configuration, run *authselect opt-out*. This will remove all authselect configuration from your system and you can then modify your configuration manually.
*opt-out*
Remove authselect configuration. This will restore nsswitch and PAM configuration under its system location and authselect will no longer manage it. Run *authselect select* to opt-in again.
$ authselect select sssd
$ authselect select sssd
$ authselect select sssd with-sudo
$ authselect select sssd with-sudo
$ cat {AUTHSELECT_CONFIG_DIR}/user-nsswitch.conf
passwd: files sss
group: files sss
hosts: files dns myhostname
sudoers: files
$ cat {AUTHSELECT_CONFIG_DIR}/user-nsswitch.conf
passwd: files sss
group: files sss
hosts: files dns myhostname
sudoers: files
0: Success. 0: 成功。
1: Generic error. 1: 一般エラー。
2: Profile or configuration was not found or the system was not configured with authselect. 2: プロファイルまたは設定が見つからないか、システムが authselect で設定されていません。
3: Current configuration is not valid, it was edited without authselect. 3: 現在の設定は無効です。authselect なしで修正されました。
4: System configuration must be overwritten to activate an authselect profile, --force parameter is needed. 4: authselect プロファイルを実行するには、システム設定を上書きする必要があります。--force parameter が必要です。
5: Executed command must be run as root. 5: コマンドは、root で実行する必要があります。
*-a, --all* *-a, --all*:
*apply-changes* [-b] [--backup=NAME] *apply-changes* [-b] [--backup=NAME]
authselect(8) authselect(8)
Use *authselect check*. The output will tell you if you have 1) configuration generated by authselect 2) non-authselect configuration or 3) configuration that was generated by authselect but modified manually at some point. *authselect check* を使用します。この出力では、(1)authselect 設定、(2)authselect 以外の設定または (3) で生成された設定があるものの、ある時点で手動で変更したかを伝えます。
*{AUTHSELECT_DCONF_DIR}/{AUTHSELECT_DCONF_FILE}* *{AUTHSELECT_DCONF_DIR}/{AUTHSELECT_DCONF_FILE}*
*{AUTHSELECT_DCONF_DIR}/locks/{AUTHSELECT_DCONF_FILE}* *{AUTHSELECT_DCONF_DIR}/locks/{AUTHSELECT_DCONF_FILE}*
authselect [--debug] [--trace] [--warn] command [command options]
authselect [--debug] [--trace] [--warn] コマンド [command options]
*{AUTHSELECT_NSSWITCH_CONF}* *{AUTHSELECT_NSSWITCH_CONF}*